Cisco RV132W Administration Manual page 25

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
Virtual Circuit
SRA (Seamless Rate Adaption)
DSL Modulation
In the IPoA Settings section, enter the following information:
Internet IP Address
Subnet Mask
Default Gateway
Static DNS 1 & 2
In the Other Settings section, enter the following information:
NAT (Network
Address Translation)
MTU (Maximum
Transmission Unit)
Size
The Virtual Path Identifier (VPI) and
Virtual Channel Identifier (VCI) are
values used to identify your line to your
ISP's ATM network.
Check Enable or Disable to enable or
disable the SRA, a protocol which, by
decoupling the modulation and
framing layer, can change the
transmission data rate parameters
(applied by the modulation layer).
Select the DSL modulation from the
drop-down list. The default DSL
modulation is Multimode
(recommended).
Enter the IP address (Hint 192.168.100.100).
Enter the subnet mask (Hint 255.255.255.0).
Enter the default gateway (Hint 192.168.100.1).
Enter the IP address of the primary and or
secondary Static DNS in the fields (Hint 1.2.3.4).
If enabled, all outbound traffic through this interface is
NAT'ed. If disable, all outbound traffic through this
interface is routed.
MTU is an advanced configuration that allows you to
determine the largest data size permitted on your
connection. Select Auto (default) or Manual to
configure manually.
Enter the size of bytes. (Range 576 - 1500, Default
1500).
3
23