Cisco RV132W Administration Manual page 19

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
DSL Modulation
In the DSL Settings for PTM transfer mode (RV134W) enter the following
information:
Transfer Mode
SRA (Seamless Rate Adaption)
DSL Modulation
In the Bridged Settings section for both the ATM and PTM (RV134W) transfer
modes, enter the following information:
Ethernet LAN Ports
2.4G Wireless Ports
5G Wireless Ports (RV134W only)
In the Other Settings section for both the ATM and PTM (RV134W) transfer
modes, enter the following information:
VLAN & VLAN ID
MTU (Maximum
Transmission Unit)
Select the DSL modulation from the
drop-down list. The default DSL
modulation is Multimode
(recommended).
PTM
Check Enable or Disable to enable or
disable the SRA, a protocol which, by
decoupling the modulation and
framing layer, can change the
transmission data rate parameters
(applied by the modulation layer).
Select the DSL modulation from the
drop-down list. The default DSL
modulation is Multimode
(recommended).
Select the Ethernet LAN ports. (LAN1,
LAN2, LAN3 or LAN4 - [RV134W only]).
Select SSID1 (default).
Select SSID1 (default).
If enabled, all outbound traffic through this interface is
tagged with the configured VLAN ID.
MTU is an advanced configuration that allows you to
determine the largest data size permitted on your
connection. Select Auto (default) or Manual to
configure manually.
3
17