Cisco RV132W Administration Manual page 23

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
In the Other Settings section for both the ATM and PTM (RV134W) transfer
modes, enter the following information:
NAT (Network
Address Translation)
VLAN & VLAN ID
802.1p Priority (For
ATM transfer mode
only)
MTU (Maximum
Transmission Unit)
Size
MAC Address Clone
If enabled, all outbound traffic through this interface is
NAT'ed. If disable, all outbound traffic through this
interface is routed.
If enabled, all outbound traffic through this interface is
tagged with the configured VLAN ID.
Enter a range from 0 to 7. All outbound traffic of this
interface will be tagged with the configured 802.1p
priority. If it conflicts with the QoS setting, the QoS
setting will take precedence.
MTU is an advanced configuration that allows you to
determine the largest data size permitted on your
connection. Select Auto (default) or Manual to
configure manually.
Enter the size of bytes. (Range 576 - 1500, Default
1500).
At times, you may need to set the MAC address of the
device WAN port to be identical to your PC or some
other MAC address. This is called MAC address
cloning.
For example, some ISPs register your computer's MAC
address when the service is first installed. When you
place a router behind the cable modem or DSL
modem, the MAC address from the device WAN port is
not recognized by the ISP.
In this case, to configure your device to be recognized
by the ISP, you can clone the MAC address of the WAN
port to be the same as your computer's MAC address.
To configure a MAC address clone select Enable.
3
21