Cisco RV132W Administration Manual page 31

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
MAC Address
When the Internet Connection Type is PPPoA:
In the DSL Settings section, enter the following information:
Transfer Mode
Multiplexing
QoS Type
Auto Detect
Virtual Circuit
SRA (Seamless Rate
Adaption)
To set the MAC address of the device WAN port, do
one of the following:
To set the MAC address of the WAN port to your PC
MAC address, click Clone My PC's MAC.
To specify a different MAC address, enter it in the MAC
Address field.
ATM
Defines the way in which different protocols are
handled within a DSL virtual circuit. You can choose
between a Logical Link Control (LLC) encapsulation
and Virtual Channel (VC) multiplexing.
Select the DSL Quality of Service (QoS): Unspecified
Bit Rate (UBR), Constant Bit Rate (CBR), Variable Bit
Rate - real time (VBR-rt), Variable Bit Rate - non-real
time (VBR-nrt). CBR provides the best guarantee of low
latency; UBR provides none, but is typically used for
most broadband data services.
Pcr Rate - When the QoS is set to CBR, VBR-rt, or VBR-
nrt, enter the Peak Cell Rate (PCR) in cells per second.
Scr Rate - When the QoS is set to VBR-nrt or VBR-rt,
enter the Sustained Cell Rate (SCR) in cells per
second.
Check Enable to enable or Disable to disable
automatic detection of the VPI and VCI values that
identify your line to the ATM network.
The Virtual Path Identifier (VPI) and Virtual Channel
Identifier (VCI) are values used to identify your line to
your ISP's ATM network.
Check Enable or Disable to enable or disable the SRA,
a protocol which, by decoupling the modulation and
framing layer, can change the transmission data rate
parameters (applied by the modulation layer).
3
29