Cisco RV132W Administration Manual page 108

VPN
Site-to-Site IPsec VPN
STEP 6
NOTE
NOTE
STEP 1
STEP 2
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
• DPD Action - Select Terminate if you want to end the session or Reconnect
to reconnect.
f. Extended Authentication - To enable XAUTH.
Click Save.
(For RV132W only) If you have a VPN connection already configured, you cannot
add another without deleting the existing VPN connection.
Managing VPN Policies
Before you create an Auto VPN Policy, ensure that you create the IKE policy based
on which you want to create the auto VPN policy.
To manage VPN policies:
Choose VPN > Site-to-Site IPsec VPN > Advanced VPN Setup. In the VPN Policy
Table, click Add Row.
In the Add / Edit VPN Policy Configuration section:
a. In the Policy Name field, enter a unique name to identify the policy.
b. In the Policy Type field, choose one of the following options:
• Auto Policy—Some parameters for the VPN tunnel are generated
automatically. This requires using the Internet Key Exchange (IKE) protocol
for negotiations between the two VPN endpoints.
• Manual Policy—All parameters (including the keys) for the VPN tunnel are
manually entered for each end point. No third-party server or organization is
involved.
c. VPN Failover — Check Enable to enable VPN failover. If enabled, the
"Interface" configuration will gray out. The VPN tunnel will always build on the
active WAN interface.
d. Interface—Select which WAN interface the VPN tunnel is on.
e. Redundant Enable — With Redundant Enable selected, if the device fails to
establish the tunnel with the "Remote Endpoint", (configured on the same
page), it will try to establish the tunnel with the "Redundant Remote Endpoint".
f. Redundant Remote Endpoint—Select the type of identifier that you want to
provide for the gateway at the remote endpoint: IP address or FQDN. Enter the
IP address or the FQDN.
6
106