Cisco RV132W Administration Manual page 33

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide
Authentication Type
In the IPv6 Settings section, enter the following information:
For IPv6
Mode
Address Mode
Select the authentication type from the drop-down
list.
Auto Negotiation - The server sends a
configuration request specifying the security
algorithm set on it. The device then sends back
authentication credentials with the security type
sent by the server.
PAP - Password Authentication Protocol.
CHAP - Challenge Handshake Authentication
Protocol.
MS-CHAP - Microsoft version of the Challenge-
Handshake Authentication Protocol.
MS-CHAP2 - Microsoft version of the Challenge-
Handshake Authentication Protocol version 2.
IPv6
Select Dynamic or Static.
If you select Dynamic, it means that if the RA (Router
Advertisement) message that the device receives, has
an M Flag "0", the device uses SLAAC (Stateless
Address Auto-configuration) to get the IPv6 address; if
the M Flag is "1", the device uses DHCPv6 to get the
IPv6 address.
If you select Static, enter the following information:
• IPv6 Address
• IPv6 Prefix Length
• Default IPv6 Gateway
• IPv6 DNS1 & DNS2
The IPv6 connection is PPPoA as well. The IPv4 and
IPv6 connection share the same PPPoA setting.
3
31