Controls On The Belt Grinder - Dick SM-100 Operating Instructions Manual

Putting into operation
Figure 7.6 – Belt alignment and running
[3] Adjusting screw
1 Undo the fastening screws [2] of the right-hand side panel
[1],
2 push the right-hand side wall [1] to the rear and remove,
3 turn the grinding belt by hand, at the same time checking
whether it drifts to the side,
4 if necessary, use the adjusting screw [3] so that the belt runs
in the middle of the deflection pulley.
5 Screw the side panel back on tight.
6 If necessary, readjust while the motor is running.
7.6

Controls on the belt grinder

Figure 7.7 – Switches
[1] Switch for switching off (red, 0)
[2] Switch for switching on (green, I)
3
Belt grinder SM-100
7
1
21