Mounting The Primary Lens - NEC iS8-2K Installation And Adjustment Manual

4-3. Mounting the Primary Lens

The following lens units can be used with the iS10.
Highlite Series projector lenses: TL-1ZHX, TL-2ZX, TL-4Z
DLP-CINEMA lenses for the iS10: CL-2ZX, CL-4ZX
Normally, please use approved DLP-CINEMA lenses for the iS10.
As a special case, Highlite Series lenses can be used; however,
note that these lenses should not be used when a high-contrast
image is desired.
Contact your dealer for more information.
Method 1. Mounting DLP-CINEMA Lenses
Loosen the 2 screws of the lens hood and remove
the lens hood.
Remove the rubber at the projector side surface.
Once the rubber is removed, a lens fastening screw is acces-
sible inside. Please loosen this screw.
Align the hole of the lens side to the axis of the
lens mount and attach.
Tighten the lens fastening screw until the lens is
fastened.
Attach the rubber to the lens fastening screw holes.
Attach the connector.
Attach the dust prevention cover (sponge) to the
lens. (Supplied with the projector.)
Attach the lens hood and tighten the screw.
6
1
3
7
8
2
5
4
27