Important Safeguards; Power Supply - NEC iS8-2K Installation And Adjustment Manual

Important Safeguards

These safety instructions are to ensure the long
life of your projector and to prevent fire and
shock. Please read them carefully and heed all
warnings.
Installation
1. Place the projector on a flat, level surface in
a dry area away from dust and moisture.
Tilting the front of the projector up or down
from level could reduce lamp life.
Do not put the projector on its side when the
lamp is on.
Doing so may cause damage to the projec-
tor.
2. Do not place the projector in direct sunlight,
near heaters or heat radiating appliances.
3. Exposure to direct sunlight, smoke or steam
could harm internal components.
4. Handle your projector carefully. Dropping or
jarring your projector could damage internal
components.
5. To carry the projector, a minimum of four per-
sons are required.
Do not hold the lens part and the three an-
amorphic lens shafts with your hand. Other-
wise the projector may tumble or drop, caus-
ing personal injury.
6. Do not place heavy objects on top of the pro-
jector.
7. If you wish to have the projector installed on
the ceiling:
a Do not attempt to install the projector your-
self.
b The projector must be installed by quali-
fied technicians in order to ensure proper
operation and reduce the risk of bodily in-
jury.
c In addition, the ceiling must be strong
enough to support the projector and the
installation must be in accordance with
any local building codes.
4
d Please consult your dealer for more infor-
mation.
e Do not attempt to stack projectors on the
ceiling.

Power Supply

1. The projector is designed to operate on a
power supply of 1.7KW 100-120VAC 50/60Hz
for iS8-2K or of 2.8KW 200-240VAC 50/60Hz
for iS10. Ensure that your power supply fits
this requirement before attempting to use
your projector.
2. Consult your dealer for installing the power
cord to the projector. DO NOT install the
power cord by yourself. Doing so may cause
a fire or electric shock.
3. Handle the power cord carefully and avoid
excessive bending. Do not place any heavy
objects on the power cord. A damaged cord
can cause electric shock or fire.
4. If the projector will not be used for an ex-
tended period of time, disconnect the plug
from the power outlet.
5. Placing the power cord and the signal cable
closely to each other can cause beat noise.
If this happens, keep the two separated so
that beat noise is not generated.
Beat nise is corruption of the picture often
seen as a rolling band moving through the
image.
6. Do not touch the power plug during a thun-
derstorm. Doing so can cause elecrical shock
or fire.
Cleaning
1. Unplug the projector before cleaning.
2. Clean the cabinet periodically with a damp
cloth. If heavily soiled, use a mild detergent.
Never use strong detergents or solvents such
as alcohol or thinner.
3. Use a blower or lens paper to clean the lens,
and be careful not to scratch or mar the lens.