Test Pattern Setting; Lamp Brightness Adjustment - NEC iS8-2K Installation And Adjustment Manual

9-5. Test Pattern Setting

Select the MCGD and TCGD files to set the target color
hue of the projected test pattern.
1. Click [File Select] at the right side of the MCGD
File Select section.
2. Select the "MCGD" file and click [OK].
3. Click [File Select] at the right side of the TCGD
File Select section.
4. Select the "TCGD" file and click [OK].
When projecting a movie and when there is a large screen such
as in a theater, please set P7V2 THEATER; in post production
and other creative relationships, please set P7V2 TELECINE.
(When there are different instructions when showing a movie,
please follow those instructions.)

9-6. Lamp Brightness Adjustment

Lamp brightness is controlled using the adjusting bar. The AUTO mode permits the set brightness to be
maintained automatically.
In the case of movies, adjust the brightness of your DLP Cinema Projector to approximately 12 or 14 (ftl).
Note:
The use of a small iris will disable automatic brightness adjustment (AUTO mode).
Adjustable Range of Lamp Brightness
iS10 Projector
iS8-2K Projector
Click Basic -> Lamp of the setup screen tree to change the brightness level.
Manual Adjustment
1. Click [Adjust] and move the adjustable bar with
the mouse to adjust the brightness at screen
center to the target brightness.
Automatic Mode
1. Click [Auto] and move the adjustable bar with
the mouse to adjust the brightness at screen
center to the target brightness.
Notes:
• The set value will be invalidated after replacement of the lamp,
therefore, you must set lamp brightness once again.
• If you set 100% of the lamp output, automatic brightness
adjustment (AUTO mode) will be disabled.
: 8 levels between 1.2 kW and 2 kW
: 31 levels between 0.45 kW and 1.25 kW
47