Setting Up Your Projector (Model Is8-2K); Connecting The Power Cord - NEC iS8-2K Installation And Adjustment Manual

3. Setting Up Your Projector (Model iS8-2K)

3-1. Connecting the Power Cord

After making sure that the main power switch of your projector is turned off, plug its power cord into an
earthed, three-pin power outlet (power supply: 100-120 VAC or 200-240 VAC).
CAUTION
• Consult your dealer for installing the power cable to the projector. Do not install the power
cable by yourself.
• For equipment safety, be sure to provide ground connection. To prevent the risk of electric
shock, grounding must be conducted by a qualified electrician. Make sure to connect the
grounding conductor before plugging the power connector.
Be sure to secure the power plug as follows:
(To prevent falling out)
(1) Lift the wire stopper.
Wire stopper
CAUTION
In order to protect the projector from being damaged, DO NOT unplug the projector's power cable from the wall outlet:
immediately after the cooling fan stops working (the fan continues working for 3 minutes after the projector is tuned off); and
while a flash memory is in use (the memory data could be destructed).
16
(2) Plug the projector's power cord into
the wall outlet.
Power plug
Plug to a 100-120 VAC or 200-240 VAC
three-pin power outlet.
(3) Bring the wire stopper down to secure
the power plug.