Table of Contents
Advertisement
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. You
can program the type of alarm
tone.
You can cancel an alarm at any
time without deactivating the
anti-theft alarm by pressing but-
ton 1 on the remote control.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The anti-theft alarm telltale light
then signals the reason for the
alarm for one minute.
The meanings of the flash codes
are as follows:
Flashes 1x: Motion sensor 1
Flashes 2x: Motion sensor 2
Flashes 3x: Ignition switched
on with unauthorised key
Flashes 4x: Disconnection of
the anti-theft alarm from the
motorcycle's battery
Flashes 5x: Motion sensor 3
Deactivation without
remote control
Kill switch in operating position
(run).
Switching on ignition (
Turn indicators flash once.
Confirmation tone sounds
once.
Anti-theft alarm is deactivated.
Deactivation with remote
control
Press button 1 on the remote
control once.
See also the other func-
tions of the remote control
for the central locking system.
If the alarm function is de-
43).
activated by the remote
control and the ignition is not
subsequently switched on, the
alarm function automatically goes
active again after 30 seconds if
"Activation after ignition OFF" is
programmed.
4
69
z
Advertisement
Chapters
Table of Contents
