BMW K 1600GTL Exclusive Rider's Manual page 37

DTC intervention
DTC warning light quick-
flashes.
The DTC has detected a degree
of instability at the rear wheel
and has intervened to reduce
torque. The warning light flashes
for longer than DTC intervention
lasts. This affords the rider visual
feedback on control intervention
even after the critical situation
has been dealt with.
DTC self-diagnosis not
completed
DTC warning light slow-
flashes.
Possible cause:
Self-diagnosis did not complete,
so the DTC function is not avail-
able. The engine must be run-
ning and the motorcycle must
reach a speed of at least 5 km/h
in order for DTC self-diagnosis to
complete.
Pull away slowly. Bear in mind
that the DTC function is not
available until self-diagnosis has
completed.
DTC switched off
DTC warning light shows.
Possible cause:
The rider has switched off the
DTC system.
Switch on DTC.
DTC fault
DTC warning light shows.
Possible cause:
The DTC control unit has detec-
ted a fault. The DTC function is
not available.
You can continue to ride. Bear
in mind that the DTC function
is not available. Bear in mind
the more detailed information
on situations that can lead to a
DTC fault ( 95).
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Tyre pressure outside
permitted tolerance
General warning light
flashes red.
+ The critical tyre pressure
shows red.
Possible cause:
Measured tyre pressure is out-
side permitted tolerance.
Check the tyre for damage
and to ascertain whether the
vehicle can be ridden with the
tyre in its present condition.
If the vehicle can be ridden with
the tyre in its present condition:
3
35
z