Mute/Unmute Image - PureLink Pure Stream VIP-200 Quick Start Manual

•
Disable Channel Buttons on Receiver
o "Menu","27","Enter"
•
Display Selected Channel
o "Enter"
•
Set to Factory Default
o "Menu","333","Enter"
•
Receiver reboot
o "Menu","999","Enter"
It is typical in a point to point system that the transmitter is set on channel 0. The receiver must
match in order to receive the signal. Setting the units to factory default will set the transmitter to
channel 0 and Auto IP, and the receiver to listen for channel 0 and Auto IP.

Mute/unmute image

Press the 'Power' button to toggle mute/unmute. Note: there is an approximate four second
delay to unmute.
PureLink VIP-200 User Manual V1.0
7