Before The First Use - Hotpoint Ariston Top Blender Steam Operating Instructions Manual

en
the Steam blender.
• Never immerse the plug, lead or housing in
water or any other liquid.
• Never immerse the glass jar in water straight
after heating; allow it to cool down first.

BEFORE THE FIRST USE

When unpacking the product and remo-
ving packing material, handle the blades
carefully; they are very sharp.
Wash all parts except the motor base in hot,
soapy water. Rinse them dry. Do not immerse the
supply cord part of this appliance in water or any
other liquids. Clean the glass jar thoroughly. Be
sure to read this manual, paying special attention
to the sections on "Use your steam blender" and
"Care and Cleaning" to learn the correct methods
for taking the unit apart and cleaning.
USE YOUR STEAM BLENDER
Blades are very sharp, handle with care.
In case of power failure, when the power returns
the product goes into standby mode.
To use the blender function it is necessary to turn
the control knob to "0", press the 'on / off' but-
ton and then turn the control knob to the desired
speed.
Assembling (A)
1. To fit the Glass Jar Assembly to the base of
the Steam blender, position jar unit on the
motor base so that the arrow on the jar collar
is aligned to the arrow on the base. Push the
jar down into place.
Take care when placing the glass jar on
the motor base as incorrect positions
may damage the interlock switch and could
prevent the unit from running.
2. When you have added the required ingre-
dients to the jar, place the lid on jar before
heating or blending. Simply position the lid
over the jar and press down firmly (ensure
16
the pouring spout on the jar is covered by the
protrusion on the lid).
3. Place the water tank by sliding along the rail
on the motor base until it engages.
Place the water tank lid to protect the
water from dust, insects and other fo-
reign matter.
Disassembling
1. Switch the Steam blender off and unplug
from the mains socket. Lift the Glass Jar up
and away from the motor base.
Holding the handle only. Do not twist the
jar.
The heating element is hot when the Ste-
am blender is in heat mode, do not touch
the underside of the collar.
2. To remove the lid from the glass jar, grip the
handle of the lid firmly with one hand and lift
upwards.
3. To remove the measuring cup from the lid, lift
up and away. To position the measuring cup
over the lid, aligning with the corresponding
grooves in the lid.
Steam will escape around the measuring
cup when the Steam blender is in heat
mode, this is normal, but handle with care –
steam can burn.
Always ensure the lid and measuring cup
are positioned before blending.
Making Soup
Always cook food before blending.
1. Place the base on a level and sturdy surface.
2. Put the food into the glass jar.
Cut ingredients into small pieces (max
2-3 cm).
3. Close the glass jar lid.
4. Place the glass jar on the base and plug the
unit into an appropriate mains socket.