Transmitter Pairing - Ares Gamma V2 Quick Start Manual

PAIRING GUIDE
QUICK-START GUIDE

Transmitter Pairing

If you're completing the PTF (Pair to Fly) version, or in the unlikely event that your Gamma
370 V2's RTF radio does not operate straight out of the box, use this guide to pair your
transmitter to the included KA-6 receiver. Once the receiver has been paired to the
transmitter it should not be necessary to complete this procedure again as the ID code will
be stored in the receiver. For full pairing information and that relating specifi cally to the
KA-6 transmitter see the online manual at www.Ikonnik-rc.com
1
If previously fi tted, remove the
Gamma 370 V2's propeller during
the receiver pairing process. Place
your transmitter and receiver/
model within 1m of each other.
2
Switch the transmitter ON
and follow the pairing/binding
procedure applicable to your radio
set.
3
If using a Hitec air radio that
supports both OPTIMA and MINIMA
receivers, make sure to select the
MINIMA option for pairing then
put your transmitter into pair/bind
mode.
4
Switch the reciver ON. The LED will
initially fl ash red/blue then change
to fast-fl ashing red. Follow the
screen prompts or the guidance
detailed in your transmitter's
pairing instructions, re-booting
both the transmitter and receiver
as necessary. Pairing will be
complete when the fl ashing red
LED on the receiver turns to solid red.
Full manual available to download from: www.Ares-RC.com
Full manual available to download from: www.Ares-RC.com
300mm to 1000mm
separation
Fail-safe set button
(see full manual online for use)
NOTE: Your receiver may look
diff erent than the one shown