Chapter 6 Programming for FX9500
Introduction
This chapter provides information on programming for the FX9500 RFID Reader.
Programming for the FX9500
The primary programming interface of the FX9500 RFID reader is via LLRP protocol interface on
TCP port 5084. Applications can be developed for the reader in the following ways:
•
Applications using the RFID3 API set that is a part of the Zebra EMDK.
• The FX9500 RFID reader supports only host based RFID3 APIs for the FX9500.
• The FX9500 RFID reader cannot run embedded RFID3 API based applications.
•
Applications that are written using the LLRP interface directly.
• The FX9500 RFID reader supports only host based LLRP applications for the FX9500.
• The FX9500 RFID reader cannot run embedded LLRP based applications.
The recommended reference guide for the RFID3 API set is included in the Zebra EMDK install available on the
Zebra support site at: http://www.zebra.com/support. There is a Programmers Guide included in the Help section
that contains an introductory guide on how to perform various functions using the RFID3 API set.