Menu Level 5: Temperature Unit Display - Waeco CoolAir RT880 Installation Manual

CoolAir RT880, SP950T
➤ Press the Operating Mode button(fig. a 4,page 10), to reset the unit
to the factory settings.
✓
flashes in the digital display.
--
➤ Press the + button.
✓ The digital display shows
➤ Press the Operating Mode button (fig. a 4,page 10) to confirm your
entry.
✓ The parameters set in configuration mode are reset to the default
setting.
✓ You are now in menu level 4 and can use the + and – buttons to switch
between menu levels.
7.3.6

Menu level 5: Temperature unit display

The system can display the room temperature in °C or °F. This parameter
can be configured:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 47).
✓ The first digit of the display (fig. a 5,page 10) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + (fig. a 6,page 10) four times to switch to menu level 5.
➤ Press the Operating Mode button (fig. a 4,page 10) to change the
parameters.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Use the + and – buttons (fig. a 6 and 7, page 10) to select the tem-
perature unit that the system should display.
➤ Press the Operating Mode button (fig. a 4,page 10) to confirm your
entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 5 again and can use the + and – buttons to
switch between menu levels.
EN
.
00
Installation
51