Auto Level; Auto Level Sequence - Lippert Components ground control 3.0 Owner's Manual

Auto Level

1. After unhitching from tow vehicle and parking the tow vehicle at a safe distance away from the trailer,
press the "ON/OFF" button (Fig. 1K) and then press "AUTO LEVEL" (Fig. 1F).
NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the trailer has completed the leveling process. Failure to remain still during the leveling
cycle could have an effect on the performance of the leveling system.
NOTE: In order for hitch recognition feature to function, the auto level sequence MUST be started with the
front of the trailer above level.

Auto Level Sequence

1.
When Auto Level Sequence begins, the front of the trailer will lower to a point near level.
2.
Rear leveling jacks will be grounded.
3.
A side to side leveling sequence will occur.
NOTE: At this point on the 6-point system, the two middle jacks will be grounded to stabilize the trailer.
These two jacks do not level the trailer.
4.
Each jack will perform a final grounding touch.
5. LCD will read "AUTO LEVEL SUCCESS" (Fig. 3).
6.
LCD will then read "READY Jacks: Down" (Fig. 4A), and the green LED at the center of the four jack
buttons will be illuminated (Fig. 4B).
Rev: 08.04.2016
A
Fig. 3
Fig. 2
A
Page 5
B
Fig. 4
Ground Control® 3.0 Owner's Manual
B