Selecting A Location And Moving Welding Power Source - Miller REGENCY 250 Owner's Manual

3-2. Selecting A Location And Moving Welding Power Source

WARNING
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Disconnect input power conductors from de-
energized supply line BEFORE moving welding
power source.
FIRE OR EXPLOSION can result from
placing unit on, over, or near com-
bustible surfaces.
•
Do not locate unit on, over, or near combustible
surfaces.
•
Do not install unit near flammables.
BLOCKED AIRFLOW causes over-
heating and possible damage to unit.
•
Do not block or filter airflow.
Warranty is void if any type of filter is used.
Movement
Location And Airflow
Figure 3-2. Movement And Location Of Welding Power Source
OR
1
3
18 in
(460 mm)
FUMES can be hazardous; LACK OF
F RESH AI R AND PRO PER VEN-
TILATION can be harmful.
•
Do not breathe welding fumes.
•
Place unit only where there is a good fresh air supply
and proper ventilation.
FAL L I NG EQ UI PM ENT can cau se
serious personal injury and equipment
damage.
•
Use lifting eye to lift unit only, NOT running gear, gas
cylinders, or any other accessories.
•
Use equipment of adequate capacity to lift the unit.
1 Lifting Handles
2 Lifting Forks
Use lifting handles or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite end of unit.
3 Rating Label
Use rating label to determine input
power needs.
4 Line Disconnect Device
Locate unit near correct input
power supply.
2
4
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
18 in
(460 mm)
ssb9.1* 5/94 − ST-800 402 / ST-121 471-D
swarn11.1 3/93
OM-293 Page 3