Adjusting The Discharge-Chute Latch; Replacing The Drive Belts - Toro 37805 Operator's Manual

Note:
You will need a ratchet wrench extension
to remove the spark plug.
4. Set the gap between the electrodes on a new
spark plug at 0.76 mm (0.030 inch) as shown
in Figure 40.
1. 0.76 mm (0.030 inch)
5. Install the new spark plug, tighten it firmly, and
attach the ignition wire to the spark plug.
Note:
Ensure that the ignition wire snaps
completely into place on the spark plug.
Adjusting the
Discharge-Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge-chute latch.
1. Remove the fastener on the gear cover
41), lift the front of the cover up, and slide it back
and out of the way.
2. Loosen the bolt on the cable clamp
Figure 40
Figure 41
(Figure
g001029
1. Cable conduit
3. Grasp the cable conduit and move it toward the
front of the machine until the discharge-chute
latch fully engages the gear teeth
and
(Figure
1. Discharge-chute latch
Note:
moves into the teeth of the gear
4. Remove any slack in the cable by pulling the
cable conduit rearward.
5. Tighten the bolt on the cable clamp, being
careful not to strip the plastic part.
g001030
6. Install and secure the gear cover.
42).

Replacing the Drive Belts

If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
24
Figure 42
2. Cable clamp
Figure 43).
Figure 43
2. Gear teeth
The latch is spring loaded and naturally
g001031
(Figure 42
g001032
(Figure 43).