Summary of Contents for Sterling Power Products Aqua nautic
Page 1
Global Operation Waterproof IP 68 Power Factor Corrected 20 amp Battery Charger- One, Two & Three Bank Models English Deutsch technology www.sterling-power.com RoHS Digital www.sterling-power-usa.com compliant...
Page 2
AGM). Other types of batteries may burst, causing personal injury. The ProSport is factory set for lead-acid batteries. Use of attachments not recommended or sold by Sterling Power Products may result in a risk of fire, electrical shock or personal injury.
Wear complete eye protection and clothing protection. Avoid touching eyes while working with a battery. If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters the eye(s), flood eye(s) with running cold water for at least 10 minutes and get medical attention immediately. Never smoke or allow a spark or a flame in the vicinity of a battery or engine.
Page 4
Installation All battery chargers are designed to be permanently mounted on-board and can be mounted with the extruded fins placed vertically or horizontally. Always mount your charger in a compartment area that can be properly ventilated during use. Do not mix battery types on-board. All batteries should be of the same age and in good operating condition. Do not make any electrical connections to the ProSport or to the batteries until the following steps are completed: 11 Easy-to-follow Installation Steps: 1.
Wiring Diagrams If only two batteries are used with a 3-bank charger, then connect the unused output cable to either one of the two batteries, as instructed in item 8 above. Always connect each charger output to a single 12V battery even if the batteries are wired in series for 24V or 36V.
Page 6
Live (brown or black) 3 battery bank model AC Input Neutral (blue or white) wired to charge 3 separate Earth (yellow-green) battery banks as 3 x 12 v Output No. 1 isolated, or 10 amp fuse required Output No. 2 can be joined together on a/c side to charge one battery...
Battery type selector, Battery Type Selector On side of end cap Simply unscrew the small plastic plug at the side of the case and insert one of the other plugs you require to obtain the correct voltage. Black: Open lead acid Battery type s change so often and manufacturer s Charge 14.8 Float 13.5 have a tendency to up there charger voltages so...
AC Power and Charging LED Status Indicators The ProSport includes two LED indicators as shown below. Blue “AC Power” LED indicator: Green charge complete and charger on float. Red “Charging” LED indicator, high charge rate on Battery type selected LED, green = sealed lead acid, red = calcium, amber = open lead acid . Multi-Stage Charging Overview When the charger is turned on, the blue power indicator will turn on followed by the red charging LED indicator.
When: Monthly Item: DC Output Wiring Process: Visually inspect all wiring for cuts and abrasions.contact Sterling Power Products if charger needs to be serviced with new wiring. When: Monthly Item: AC Power Cord and Mounting Hardware Inspection Process: Visually inspect the AC power cord.
D. If there is no output when trying to read DC voltage, check each output fuse and replace as needed. If the DC voltage at each charger output is less than 13.0 volts, contact Sterling Power Products for product service.
( for latest contact detials ). The customer has to provide a proof of purchase. Sterling Power Products Ltd. will make ist best effort to repair or replace the product, if found defective, within 30 days after return of the product to the company. Sterling Power Products Ltd. will ship the repaired or replaced product back to the customer in the UK, all warantee is at the factory This warranty is in lieu of all others expressed or implied.
Need help?
Do you have a question about the Aqua nautic and is the answer not in the manual?
Questions and answers