Turning The Power Off - Canon imageFORMULA DR-3060 Startup Manual

In the case of "Add New Hardware Wizard" (Windows Me), select
"Automatic search for a better driver (Recommended)", then click Next and
then click Finish on the next screen.
In the case of "Found New Hardware Wizard" (Windows 2000), follow the
procedure described below.
1. Click Next to advance to the "Install Hardware Device Drivers" screen.
2. Select "Search for a suitable driver for my device (recommended)", and
then click Next to proceed to the "Locate Driver Files" screen.
3. Clear all of the checkmarks in the "Optional search locations", and then
click Next to proceed to the "Driver Files Search Results" screen.
4. Select "Disable the device." and then click Finish.
WARNING
If the unit ever makes a strange noise, emits smoke or a strange
odor, or becomes hot, or if the unit does not operate at all even
though the power is on, immediately turn the unit off and unplug
the power cord. Contact your dealer or service representative to
have the unit serviced.

Turning the Power Off

CAUTION
If the unit will not be used for an extended period of time, unplug
the power cord for safety's sake.
1.
Turn off the PC.
2.
Turn off the scanner.
The power switch is located on the lower right front corner of the scanner. To
turn the scanner off, press the power switch. When the power indicator turns
off, the scanner is off.
Note
Wait at least 10 seconds before turning the scanner back on.
20
Installing the Scanner