Canon imageFORMULA DR-3060 Startup Manual page 38

5.
Adjust the paper side guides.
Note
Before starting a scan, make sure that the document is loaded in the scanner
correctly. Scanning a curled document or a creased document can damage the
document.
6.
Perform the scanning operation in accordance with the normal operating
procedure for your application software.
Note
If the paper feed operation stops due to a system error or a paper jam while
the scanner is scanning, resolve the problem, make sure that the scanned
image of the last page that was fed has been stored, and then resume the
scanning operation.
Note that documents that are printed on thin paper may fall out of the
document eject tray.
7.
If the scanner is not going to be used again soon after the document has been
scanned, protect the scanner from damage by removing the document eject
guide (if it was attached to the document eject tray) and then closing the paper
feed tray and the document eject tray extension.
Note
When operating this unit, avoid wearing loose-fitting clothing, dangling
jewelry, or other material that could get pulled into the unit. Injury could
result. Be especially careful if you are wearing a necktie or have long hair. In
the event that some article or clothing does get caught in the unit, turn the
power off immediately.
34
Using the Scanner