Advertisement
VC100 ASSEMBLY
Step 5: Attach Shelf Supports
Attach the right shelf support to the barbecue by loosening the 4 existing leg bolts, approximately 3 turns
only, so that the shelf support can slide over the bolt heads. Insert a shim washer sideways behind the head
of one of the bolts and in front of the shelf support. Tighten the bolt using the 7/16" (11 mm) wrench/
ratchet or adjustable wrench. Repeat inserting shim washers behind the heads of the remaining 3 bolts.
Attach the left shelf support in the same manner.
Step 6: Install Handle Grips
Materials Required: Three handle
grip sets (six pieces total) and six
#4 x 3/4" Philips screws.
Place the top half of one handle grip, the half bearing the Vermont Castings logo, onto the right shelf support
handle. Use the holes provided as a guide. Snap the two halves of the handle grip together and secure them
using two Philips screws and a Philips screwdriver.
Repeat this procedure for the left shelf support handle grip.
Finally, attach the last handle grip to the front lid handle.
Materials Required: Left and Right shelf supports and eight
shim washers.
Page 4
Shim
Advertisement
