Ellington MAJ52ABZ5 Installation Manual page 5

5. Fan Assembly (with downrod).
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
6in. downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
6in. downrod, please proceed to instructions
following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nuts in motor
housing yoke and remove pin and clip from motor
housing yoke. Slide downrod through canopy and
yoke cover.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Thread downrod into the motor yoke until holes
for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip. Tighten yoke set screws and nuts
securely. Lower yoke cover to motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
set screw
A
electrical wiring
canopy
clip
page 4
set screw hole
stop pin
hanging ball
B
safety cable
downrod
yoke cover
yoke set screw
and nut
pin
motor housing