Adjusting The Engine Idling Speed - Yamaha TDM TWIN 900 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
WARNING
G Before installing the fuel tank,
make sure that the fuel hoses
1
are not damaged. If any fuel
hose is damaged, do not start
the engine but have a Yamaha
2
dealer replace the hose, other-
wise fuel may leak.
3
G Make sure that the fuel hoses
are properly connected and
4
routed, and not pinched.
G
Be sure to place the fuel tank
breather hose and the fuel tank
5
overflow hose in the original po-
sition.
6
7
8
9
1
1. Fuel tank breather/overflow hose
2. Fuel hose
EWA11330
1. Original position (white mark)
10. Install the rear brake fluid reservoir
holder by installing the bolt.
11. Install the panels and cowlings.
12. Install the seat.
2
Adjusting the engine idling
speed
The engine idling speed must be
checked and, if necessary, adjusted as
follows at the intervals specified in the
periodic maintenance and lubrication
chart.
1
The engine should be warm before
making this adjustment.
NOTE:
The engine is warm when it quickly re-
sponds to the throttle.
Check the engine idling speed and, if
necessary, adjust it to specification by
turning the idle adjusting screw. To in-
crease the engine idling speed, turn the
screw in direction (a). To decrease the
engine idling speed, turn the screw in
direction (b).
6-13
EAU34300