Coolant - Yamaha SUPER TENERE XT1200Z Owner's Manual

Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
To change the final gear oil
1. Place an oil pan under the final
gear case to collect the used oil.
2. Remove the final gear oil filler bolt,
the final gear oil drain bolt and
their gasket to drain the oil from
the final gear case.
1. Final gear oil filler bolt
2. Final gear oil drain bolt
3. Gasket
3. Install the final gear oil drain bolt
and its new gasket, and then tight-
en the bolt to the specified torque.
PERIODIC MAINTENANCE AND ADJUSTMENT
Tightening torque:
Final gear oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
4. Refill with the recommended final
gear oil to the brim of the filler
hole.
Recommended final gear oil:
Yamaha genuine shaft drive gear oil
SAE 80W-90 API GL-5 or SAE 80
API GL-4 Hypoid gear oil
Oil quantity:
0.20 L (0.21 US qt, 0.18 Imp.qt)
5. Check the oil filler bolt gasket for
1
damage, and replace it if neces-
sary.
6. Install the oil filler bolt and its gas-
3 2
ket, and then tighten the bolt to
the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
7. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level sur-
TIP
 The
 Make sure that the vehicle is posi-
2. Check the coolant level in the
TIP
The coolant should be between the
minimum and maximum level marks.
6-15
face and hold it in an upright posi-
tion.
coolant level must
checked on a cold engine since
the level varies with engine tem-
perature.
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
coolant reservoir.
EAU20071
EAU20095
6
be