Yamaha SUPER TENERE XT1200Z Owner's Manual page 29

"RESET" button briefly so that the trip-
meter flashes, and then push the "RE-
SET" button again for at least 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset itself auto-
matically and the display will return to
the prior mode after refueling and trav-
eling 5 km (3 mi).
Estimated traveling range display:
RANGE
11
The distance that can be traveled with
the remaining fuel in the fuel tank under
the current riding conditions is shown.
Elapsed time display:
TIME TRIP
0:06
The time that has elapsed since the
key was turned to "ON" is shown. The
maximum time that can be shown is
99:59.
INSTRUMENT AND CONTROL FUNCTIONS
This display is automatically reset
when the key is turned to "OFF".
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
"Setting mode" on page 3-16 for de-
tailed information.
Air intake temperature display:
A.TEMP
km
The air intake temperature display indi-
cates the temperature of the air drawn
into the air filter case.
This display shows the air intake tem-
perature from –9 °C to 93 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
 –9 °C will be displayed even if the
air intake temperature falls below
–9 °C.
 The accuracy of the temperature
Coolant temperature display:
˚C
25
The coolant temperature display indi-
cates the temperature of the coolant.
The coolant temperature varies with
changes in the weather and engine
load.
If the message "Hi" flashes, stop the
vehicle, then stop the engine, and let
the engine cool. (See page 6-39.)
3-14
reading may be affected when rid-
ing slowly [approximately under
20 km/h (12 mi/h)] or when
stopped at traffic signals, railroad
crossings, etc.
C.TEMP ˚C
Lo
3