Yamaha SUPER TENERE XT1200Z Owner's Manual page 31

 The "L/100km" display shows the
amount of fuel necessary to travel
100 km.
 For the UK only: The "MPG" dis-
play shows the distance that can
be traveled on 1.0 Imp.gal of fuel.
TIP
If traveling at speeds under 10 km/h (6
mi/h), "_ _._" will be displayed.
NOTICE
If there is a malfunction, "– –.–" will
be continuously displayed. Have a
Yamaha dealer check the vehicle.
Setting mode
1
MENU
Maintenance
Time Trip
Unit
Display
Brightness
Clock
All Reset
1. Setting mode display
INSTRUMENT AND CONTROL FUNCTIONS
TIP
 The transmission must be in neu-
tral and the vehicle must be
stopped to change settings in this
mode.
 Shifting the transmission into gear
and starting off, or turning the key
to "OFF", saves all settings made,
then exits the setting mode.
Push and hold the menu switch
ECA15474
"MENU" for at least 2 seconds to enter
the setting mode. To exit the setting
mode and return to the normal display,
push and hold the menu switch
"MENU" again for at least 2 seconds.
Display
This function allows you to
check and reset the "OIL"
oil change interval (dis-
Maintenance
tance traveled), and the
"FREE-1" and "FREE-2"
maintenance intervals.
3-16
Time Trip
Description
Unit
Display
Brightness
This function allows you to
check and reset the
"TIME–2" and "TIME–3"
functions. These time trips
show the total elapsed
time that the key has been
in the "ON" position. When
the key is turned to "OFF",
the time trips stop count-
ing but are not reset. The
maximum time that can be
shown is 99:59.
When the time trips reach
99:59, they automatically
reset to 0:00 and continue
counting.
This function allows you to
switch the fuel consump-
tion units between
"L/100km" and "km/L".
For the UK only: This func-
tion allows you to switch
the display units between
kilometers and miles.
When kilometers are se-
lected, the fuel consump-
tion units can be switched
between "L/100km" and
"km/L".
This function allows you to
change the items shown in
3 information displays.
This function allows you to
adjust the brightness of
the multi-function meter
unit panel to suit the out-
side lighting conditions.
3