Replacing A Turn Signal Light Bulb; Replacing An Auxiliary Light Bulb - Yamaha YBR125ESD Owner's Manual

Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1
1. Screw
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11191]
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU24204
Replacing an auxiliary light
bulb
If the auxiliary light bulb burns out, re-
place it as follows.
1. Remove the headlight unit. (See
page 6-30.)
2. Remove the auxiliary light socket
(together with the bulb) by pulling it
out.
1. Auxiliary light bulb socket
3. Remove the burnt-out bulb by pull-
ing it out.
EAU45222
1. Auxiliary light bulb
1
4. Insert a new bulb into the socket.
5. Install the auxiliary light socket (to-
6. Install the headlight unit.
6-32
1
gether with the bulb) by pushing it
in.
6