Replacing The Fuse - Yamaha YBR125ESD Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Replacing the fuse

The fuse is located behind panel B.
(See page 6-6.)
To access the fuse, disconnect the
starter relay coupler.
6
1. Starter relay coupler
2
1. Fuse
2. Starter relay holder
3. Starter relay
EAU43213 The spare fuse is located on the rear of
the starter relay holder.
To access the spare fuse, remove the
starter relay (together with its holder) by
pulling it out, then turn the starter relay
over.
1. Spare fuse
2. Starter relay holder
3. Starter relay
1
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
3
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
3
1
2
6-29
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
Specified fuse:
15.0 A
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.