Yamaha YBR125ESD Owner's Manual page 61

TIP
The electrolyte should be between the
minimum and maximum level marks.
3
1
2
1. Maximum level mark
2. Minimum level mark
3. Negative battery lead (black)
4. Positive battery lead (red)
4. If the electrolyte is at or below the
minimum level mark, add distilled
water to raise it to the maximum
level mark. NOTICE: Use only
distilled water, as tap water con-
tains minerals that are harmful
to the battery.
[ECA10611]
5. Check and, if necessary, tighten
the battery lead connections and
correct the breather hose routing.
PERIODIC MAINTENANCE AND ADJUSTMENT
4
1. Battery
2. Battery breather hose
1. Battery breather hose
6. Install the panel.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
1
2. If the battery will be stored for more
2
3. Fully charge the battery before in-
4. After installation, make sure that
6-28
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is
turned to "OFF", then discon-
nect the negative lead before
disconnecting the positive lead.
[ECA16302]
than two months, check the specif-
ic gravity of the electrolyte at least
once a month and fully charge the
battery whenever necessary.
stallation.
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed. NOTICE:
breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas ex-
pelled from the battery, the
frame could suffer structural
and external damages.
[ECA10601]
6
If the