Air Filter And V-Belt Case Air Filter Elements - Yamaha Grand filano LTF125-I Owner's Manual

Periodic maintenance and adjustment
6. Install the final transmission oil
drain bolt and its new gasket, and
then tighten the bolt to the speci-
fied torque.
TIP
Before installing the final transmis-
sion oil drain bolt and gasket, ap-
ply oil to them.
Wipe off any excess oil after
wards.
Tightening torque:
Final transmission oil drain bolt:
9 N·m (0.9 kgf·m, 6.6 lb·ft)
7. Refill with the specified amount of
the recommended final transmis-
sion oil. WARNING! Make sure
that no foreign material enters
the final transmission case.
9
Make sure that no oil gets on
the tire or wheel.
Recommended final transmission
oil:
See page 11-1.
Oil quantity:
0.10 L (0.11 US qt, 0.09 Imp.qt)
8. Install the final transmission oil fill-
er cap and its new O-ring, and
then tighten the oil filler cap.
9. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
[EWA11312]
Air filter and V-belt case air fil-
ter elements
The air filter element should be re-
placed every 16000 km (10000 mi) and
the V-belt case air filter element should
be cleaned at the intervals specified in
the periodic maintenance and lubrica-
tion chart. Service the air filter ele-
ments more frequently if you are riding
in unusually wet or dusty areas.
Checking and replacing the air filter
element
1. Place the vehicle on the center-
2. Remove the left rear panel.
3. Remove the air filter case cover by
9-13
stand.
removing the screws.
EAUU2120