Zero Configuration Setup - D-Link DCS-936L User Manual

Section 2 - Installation

Zero Configuration Setup

Note: The Zero Configuration Setup will only work with a registered D-Link Cloud Router and an active mydlink account.
Step 1:
Attach the power supply to the power input on the DCS-936L and connect it to a wall outlet or power strip. Power is confirmed when the Status LED is lit.
Step 2:
Press and hold the WPS button on the camera for five seconds. The Status LED will start to blink green. Then, press the WPS button on your router
within two minutes.
Your router will automatically assign your network settings to your camera.
Step 3:
From any computer, open a web browser, go to http://www.mydlink.com and log into your account. Once mydlink detects your camera, a New Device
Found! notice will appear in the bottom right corner. Click on the camera from the New Devices list and then click Yes to add your camera.
Your setup is complete!
D-Link DCS-936L User Manual 11