D-Link DCS-936L User Manual page 21

Section 3 - Configuration
If you are required to connect using PPPoE (Point to Point Protocol over Ethernet), check the
box to Enable and enter the User Name and Password for your PPPoE connection. Only
select this option if your camera is directly connected to your broadband modem. If it is on
a network with a router or gateway, do not select this option.
Click Next to continue.
Step 3
A Dynamic DNS account allows you to access your camera over the Internet when you have
an IP address that changes each time you connect to the Internet. If you have a Dynamic
DNS account, click Enable and enter the following details:
Server Address: Select your Dynamic DNS Server from the drop-down menu.
Host Name: Enter the host name of the DDNS server.
User Name: Enter your username or e-mail address used to connect to the DDNS.
Password:
Enter your password used to connect to the DDNS server.
Timeout:
You can setup how often the camera notifies the DDNS server of its current
global IP address by entering a whole number in hours.
Click Next to continue.
Step 4
Enter a unique name for your camera and click Next to continue.
D-Link DCS-936L User Manual 21