Frequently Asked Questions - VTech DS6771-3 User Manual

Frequently asked
questions
Below are the questions most frequently
asked about the cordless telephone.
If you cannot find the answer to your
question, visit our website at
www.vtechcanada.com or call
1 (800) 267-7377 for customer service.
My telephone Make sure the telephone
does not work base is installed
at all. properly, and battery is
installed and charged
correctly. For optimum
daily performance,
return the handset to
the telephone base after
use.
The display Disconnect the
shows No line.
telephone line cord from
I cannot hear your telephone and
the dial tone. connect it to another
telephone. If there is
no dial tone on that
other telephone either,
then the telephone line
cord may be defective.
Try installing a new
telephone line cord.
If changing telephone
line cord does not
help, the wall jack (or
the wiring to this wall
jack) may be defective.
Contact your telephone
service provider.
You may be using a new
cable or VoIP service,
the existing telephone
jacks in your home may
no longer work. Contact
your service provider for
solutions.
I cannot dial
out.
The display
shows To
register HS...
and ...see
manual
alternately. The
handset does
not work at all.
The headset
cannot pick
up any call.
It announces
"Not
registered".
51
Make sure there is a dial
tone before dialing. It
is normal if the handset
takes a second or two
to synchronize with the
telephone base before
producing a dial tone.
Wait an extra second
before dialing.
Eliminate any
background noise.
Mute the handset
before dialing, or dial
from another room in
your home with less
background noise.
The handset is
deregistered from the
telephone base.
Place the handset in
the telephone base
to register it back.
The handset shows
Registered and you
hear a beep when the
registration process
completes. This process
takes about 0 seconds
to complete.
The headset is
deregistered from the
telephone base. Follow
the steps below to
register it back.
1. Press and hold FIND
HANDSET for four
seconds. The IN USE
light turns on.
. Place the headset on
the telephone base to
register it back.
During the registration
process, the LED light
flashes alternatively in
red and blue, and turn
red after the registration
completes. This process
takes about 60 seconds.
Lift the headset, then
press ON / OFF key
on the headset. If you
hear a dial tone, the
registration is successful.