Table of Contents
Advertisement
The answering
Make sure the answering
system does
system is on. When the
not record
answering system is on,
messages.
ANS ON should display
on the handset and the
telephone base.
When the answering
machine memory is full,
it does not record new
messages until some old
messages are deleted.
If you subscribe to
voicemail service,
change the number
of rings so that your
answering system
answers before your
voicemail service
answers. To determine
how many rings activate
your voicemail service,
contact your telephone
service provider.
The messages
Press
the handset or VOL+
on the
answering
on the telephone base
system are
to increase the listening
very difficult to
volume.
hear.
The answering
Make sure you have
system does
set the date and time.
See Configure your
not announce
telephone section.
the correct day
of the week
for recorded
messages time
stamp.
The messages
If a caller leaves a very
on the
long message, part of
answering
it may be lost when
system are
the answering system
incomplete.
disconnects the call after
the preset recording time.
If the memory on the
answering system
becomes full during a
message, the answering
system stops recording
and disconnects the call.
/VOLUME on
54
The answering
Make sure you enter the
system does
correct remote access
not respond
code.
to remote
Make sure you are
commands.
calling from a touch-
tone telephone. When
dialing a number, there
should be tones. If there
are clicks, then it is not
a touch-tone telephone
and cannot activate the
answering system.
The answering
system may not
detect the remote
access code when
your announcement is
playing. Wait until the
announcement is over
before entering the code.
Make sure your
I subscribe to a
computer is powered
nontraditional
on, and your Internet is
telephone
working properly.
service that
uses my
Make sure to plug your
computer
USB telephone adapter
to establish
into a dedicated USB
connections,
port on your computer.
and my
Do not plug into a
telephone
multiple port USB hub
doesn't work.
(USB splitter) that is not
powered.
In a few rare instances,
the USB port on your
computer may not have
enough power. In these
instances, try using a
USB hub with its own
external power supply.
If you are using
a firewall, it may
prevent access to your
nontraditional telephone
service. Contact your
service provider for more
information.
Advertisement
Table of Contents
