Table of Contents
Advertisement
DVIPRO1000
3.0 CONNECTIONS
Connect the single inputs to the respective connector on the back of the
DVIPRO1000.
For inputs 1 and 2, available only on connector HDD15p, in the case of
connection of Component, YC or CVBS signals, the specific VGA-5BNC type
ADC201 adapter cable must be used on which correspondence is as follows:
GREEN = CVBS, or Y of YC or Y of the component
BLUE
RED
For inputs 3, 4, 5 and 6 available on connector HDD15p. and on 3 separate
BNC, connect only one source for each input
For inputs 7 and 8, available on connectors DVI-I, HDMI and 3 separate BNC,
connect only one source for each input
Never connect more than 1 source at a time to the universal inputs
in order to prevent damage to the sources or to the DVIPRO1000
Connect the destinations to the related output connectors of the
DVIPRO1000. Resolution can be set for each output
channels of each output will have the same resolution and setting of the
image.
Connect the inputs and balanced audio outputs on the dedicated terminals.
As regards the HDMI input, as the digital audio signal is already contained in
the HDMI signal, it is not necessary to connect a separate audio signal on IN8
as the DVIPRO1000 is able to decode the audio present in the HDMI signal
and convert this into a traditional analogue signal on the selected output.
If a separate audio is to be associated with the 8 HDMI input, it is necessary
to program the format of input IN8 as DVI instead of HDMI.
ELPRO Video Labs s.r.l.
St.da della Pronda, 45/B 10142 Torino ITALY
Tel.+39 0117701583 – Fax +39 011703751
8x2 UNIVERSAL SCALER MATRIX SWITCHER
& EFFECT CONTROL
= C of the YC or Pb of the component
= Pr of the component
WARNING
: the DVI and VGA
.
7
7
Advertisement
Table of Contents
