ELPRO DVIPRO1000 Manual page 10

DVIPRO1000
4.1 Selection of output resolution
- Volume keys: they flashes yellow for each volume variation. In the
case of a mute condition , both the + and – keys will be on (green
for OUT1 , red for OUT2 , yellow for both channels)
- Out channel key : the green light stands for the OUT1 channel , the
red light for the OUT2 channel . The volume , resolution and overlay
keys will be active for the selected output channel
To define output resolution, proceed as follows:
With the "MODE" key, select the output channel on which the new resolution
is to be set according to the indications screen-printed beside the key.
Then, press the "RES" key: an OSD menu is displayed in the output screen
page with the list of the selectable resolutions, while the currently selected
resolution will be shown on the LCD display.
Continue to press the "RES" key until the resolution desired is highlighted on
the LCD and on the video.
After a brief pressure on the "MODE" key, the programming becomes
effective and the machine will perform a restart cycle of around 10 seconds,
at the end of which the new resolution will be activated.
N.B. the VGA analogue output and the DVI digital output of the single
output channel always have the same resolution.
ELPRO Video Labs s.r.l.
10
St.da della Pronda, 45/B 10142 Torino ITALY
Tel.+39 0117701583 – Fax +39 011703751
8x2 UNIVERSAL SCALER MATRIX SWITCHER
& EFFECT CONTROL
10
1