Yamaha YZ450F Owner's Service Manual page 213

TIP
Make sure that the alignment mark "c" on the
exhaust camshaft sprocket and the alignment
mark "d" on the intake camshaft sprocket are
aligned with the edge of the cylinder head.
d
ECA33DD029
NOTICE
Do not turn the crankshaft during the cam-
shaft installation. Damage or improper
valve timing will result.
d. Install the clips, the camshaft caps and the
bolts (camshaft cap).
Bolt (camshaft cap)
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Before installing the clips, cover the cylinder
head with a clean cloth to prevent the clips
from coming off into the cylinder head cavity.
• Apply the engine oil to the threads and con-
tact surfaces.
• Tighten the bolts to the specified torque in two
or three steps in the proper tightening se-
quence as shown.
ECA33DD030
NOTICE
The bolts (camshaft cap) must be tightened
evenly, or damage to the cylinder head,
camshaft caps, and camshaft will result.
3
1
E
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3
4
8
2 6
2. Install:
• Timing chain tensioner
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. While pressing the tensioner rod lightly with
your fingers, use a thin screwdriver to wind
the tensioner rod up fully clockwise.
c
b. With the tensioner rod fully wound and the
chain tensioner UP mark "a" facing upward,
install the gasket "1", the timing chain ten-
sioner "2", and the gasket "3", and tighten
the bolt "4".
c. Release the screwdriver, check that the ten-
sioner rod comes out smoothly, and tighten
the gasket "5" and the cap bolt "6".
7
5
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5-18
CAMSHAFT
Bolt (timing chain tensioner)
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Tensioner cap bolt
6 Nm (0.6 m·kgf, 4.3 ft·lbf)
5
6