Yamaha YZ450F Owner's Service Manual page 159

3. Tighten:
• Lower handlebar holder nut
Lower handlebar holder nut
40 Nm (4.0 m·kgf, 29 ft·lbf)
4. Install:
• Handlebar grip "1"
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Slightly coat the handlebar left end with a
rubber adhesive.
b. Install the handlebar grip on the handlebar
by pressing the grip from the left side.
c. Wipe off any excess adhesive with a clean
cloth.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Install the handlebar grip to the handlebar so
that the line "a" between the two arrow marks
faces straight upward.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Install:
• Handlebar grip "1"
• Handlebar grip "2"
• Handlebar grip "3"
• Launch control switch "4"
• Clamp "5"
Engine stop switch screw
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
Clutch lever holder bolt
5 Nm (0.5 m·kgf, 3.6 ft·lbf)
Launch control switch screw
1.3 Nm (0.13 m·kgf, 0.94 ft·lbf)
TIP
• The engine stop switch, the clutch lever, the
clutch lever holder and the launch control
switch should be installed according to the di-
mensions shown.
• Pass the engine stop switch lead through the
middle of the clutch lever holder.
6. Install:
• Right grip "1"
• Collar "2"
Apply adhesive to the tube guide "3".
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
quer thinner.
• Install the grip to the tube guide so that the
grip match mark "b" and tube guide slot "c"
form the angle as shown.
4-35
HANDLEBAR