Installing The Seat; Charging The Battery - Toro Z MASTER Z500 series Setup Instructions

Step
6

Installing the Seat

Parts needed for this step:
1 Seat
4
Flange nuts
Procedure
1. Remove the seat from the crate.
2. Position the seat into the holes in the seat
frame (Figure 13).
Figure 13
3. Secure the seat with 4 flange nuts (Figure 13).
4. If needed, attach the two connectors onto the
seat switch (Figure 14).
Figure 14
Step
7

Charging the Battery

No Parts Required
Procedure
Charging the battery produces gasses that
can explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the
battery in an enclosed space.
Important: Do not run the machine with
the battery disconnected; electrical damage
may occur to the engine.
Charge the battery. Refer to the Operator's Manual
for instructions.
6