Checking The Tire Pressure - Toro Z MASTER Z500 series Setup Instructions

Step
13
No parts required
14
No parts required
Operator's Manual
Parts Catalog
Engine Owner's Manual
15
Registration Card
Safety Video
Key
Step
1
Removing Parts from the
Crate
No Parts Required
Procedure
Remove the tires and the parts for the ROPS from
the shipping crate.
Step
2

Checking the Tire Pressure

No Parts Required
Procedure
Pressure: 13 psi (90 kPa)
1. For entry level models only, check the air
pressure in the front tires.
Note: If there is no valve stem located in the
front tires, then it is a semi-pneumatic tire and
does not need to be checked.
2. Check the air pressure in the rear tires.
Description
Step
Raising the Machine Up and
Installing the Drive Wheels
Parts needed for this step:
Procedure
1. Remove the screws holding the right angle
2
Qty.
–
Add fuel to the machine.
Check the machine before delivery
–
to the customer.
1
1
1
Delivering the machine to the
customer.
1
1
2
Figure 1
3
2 Rear wheels
retaining plate to the crate (Figure 2).
Use