Toro Z MASTER Z500 series Setup Instructions page 9

7. Align the holes in the air cleaner bracket with
holes in the valve covers (Figure 24).
8. Install the long carburetor bolts into the
air cleaner base and into the carburetor
(Figure 23).
Figure 23
9. Install the hose clamp onto the hose and install
the hose to the air cleaner (Figure 24).
10. Install the bolts into the back of the air cleaner
bracket and into the motor (Figure 24).
11. Tighten the hose clamp.
Figure 24
12. Install the front engine cover with 4 screws.
Figure 25
Step
10
Checking the Spindles for
Grease
Parts needed for this step:
Number 2 general purpose lithium base
1 tube or molybdenum base grease. (Purchase
separately.)
Procedure
1. Remove the belt covers on domestic machines
(Figure 26).
Figure 26
2. Remove the belt covers and bolts on
international machines (Figure 27).
9