Table of Contents
Advertisement
1. Tongue
2. Ball socket
3. Coupler lever, locked
position
3. Close the coupler lever making sure it is securely
locked.
4. Install the pin to lock the coupler lever (Figure 8).
5. Cross the safety chains and attach them to the holes
on the hitch (Figure 8).
6. Plug the blower wire harness connector to the tow
vehicle connector. Check to make sure the brake
lights illuminate properly with the brake pedal
applied and the taillights flash when the turning
signals are use.
Figure 8
4. Safety chains
5. Locking pin
6. Hitch tube holster
Product Overview
Controls
Engine Stop
Press the Engine Stop button to stop the engine
(Figure 9).
1. Rotate nozzle left
2. Rotate nozzle right
3. Decrease blower output
(Pressing 3 and 4 together
returns engine to idle)
Engine Start
After completing the starting sequence, press the Engine
Start button to start the engine (Figure 9). Refer to
Starting the Engine for the starting sequence.
Nozzle Direction
Press the right or left button to rotate the nozzle to the
desired direction (Figure 9).
Engine Speed
Press the Fast (rabbit) or Slow (turtle) button to increase
or decrease the speed of the engine (Figure 9).
Ignition Switch
The ignition switch (Figure 10) which is used to start
and stop the engine, has three positions: OFF, RUN and
START. Rotate key clockwise to the START position
to engage the starter motor. Release the key when the
engine starts. The key will move automatically to the ON
11
1
2
3
4
5
6
g017705
Figure 9
4. Increase blower output
5. Engine start
6. Engine stop
Advertisement
Table of Contents
