Table of Contents
Advertisement
length of time that the Start Relay Control can
be active is 25 seconds from pressing the Rotate
Right button. The Start button can be pressed
multiple times while Engine Start Enable Condition
is active. After the Engine Start Enable Condition
expires, the Engine Start Enable Sequence must be
performed again in order to energize the Start Relay
Control with the Start button.
Note: If the sequence is aborted or the Engine
Start Enable Condition expires, normal functionality
of the Rotate Right and Left buttons will return to
control the Chute Motor.
Figure 15
1. Rotate nozzle left
2. Rotate nozzle right
3. Decrease blower output
(Pressing 3 and 4 together
returns engine to idle)
Important: Do not engage starter for more
than 10 seconds at a time. If engine fails to
start allow 30 second cool-down period between
attempts. Failure to follow these instructions
can burn out starter motor.
5. After the engine starts, move the choke control to
the off position. If the engine stalls or hesitates,
move the choke back to the ON position for a few
seconds, then set the engine speed to the desired
setting. Repeat this as required.
Stopping the Engine
1. Decrease the engine speed midway between the
slow and fast positions.
1
2
3
4
5
6
g017705
4. Increase blower output
5. Engine start
6. Engine stop
2. Let the engine idle for 20 seconds.
3. Press the STOP button on the remote control.
4. If leaving the machine, rotate the key to the OFF
position and remove it from the engine (Figure 14).
Start, Stop and Inactivity Time
out
The remote control activates (powers up) when
any push button is pressed. Blinking TX and RX
LEDs indicate that the remote control is alive and
communicating with the base unit. To conserve battery
power, the remote control stays active for approximately
three (3) seconds before automatically shutting down
unless there is button activity within the three second
limit. When the unit times out and powers down, all
remote control LED activity stops (Figure 16). Pressing
any button will reactivate the remote control
3
4
5
1. Associate
2. Disassociate
3. TX
Power Save Mode
The base unit will revert to Power Save Mode ― until a
power cycle occurs ― if the base unit is active for more
than 2.5 hours without communication from the remote
control. Power Save Mode is a low current state of the
base unit. In Power Save Mode, the base unit will not
communicate with the remote control, will not activate
outputs, and will not generally function as normal.
• When in the time-out mode the engine will not run
(or will quit running) and the remote control will
not control any function.
16
g017704
Figure 16
4. RX
5. LINK
Advertisement
Table of Contents
