Installed Co Mpo Nents - Seagate 8-Bay Rackmount NAS User Manual

Installed components
The rear chassis is shipped with the following:
1. PCIe: SATA extender (do not remove the SATA extender or add third-party PCIe boards to the NAS)
2. Battery: 3V Lithium Battery (CR2032)
3. CPU: Intel® Ivy Bridge 2.3GHz
4. RAM: 4GB DDR3 DIMM ECC (x1)
5. Power supplies: 100 to 240 VAC, 50 to 60 Hz (x2)
Replace the ba ery
The battery is located next to the PCIe slots and protected by the extension card support. To remove the
extension card support, you will need a Torx screwdriver with a T6 point.
Use caution when replacing the battery. There is a strong risk of explosion if the battery is replaced by an
incorrect type.
1. Power off the system, unplug the power supply, and remove the rear cover as described above.
2. Remove the screws from the extension card support.
Seagate 8-Bay Rackmo unt NAS 2/17/16 63