Commencing Projection - Epson EMP-715 Owner's Manual

Commencing projection

1
Press the [Power] button to turn on the power supply.
The Operation Indicator will begin to blink in green, and projection will be started.
Power
The operation indicator will change from blinking to being illuminated in green after a
while.
Point
Button operations are not possible when the Operation Indicator is blinking in green.
2
Open the remote control cover when a remote control is to be used.
32 - Projection
Power
Help
Source
Enter
A message stating [No image
signals being input] will be dis-
played when no image sig-
nals are being input. (Note
that there are cases where
this will not be displayed
depending on the no-signal
display setting.)
(see page 62)
Freeze
Power
A/V Mute
Set the R/C ON OFF switch to [ON] first of all
when using the remote control unit
Operation Indicator
Blinking in green → Illuminated
Help
Power
R/C ON
E-Zoom
OFF
3
Enter
Esc