Epson EMP-715 Owner's Manual page 74

G Messages
[Not Supported]
will be displayed
[No Signal]
will be displayed
A message stating
[Error discovered
in the EasyMP
system] will be
displayed.
A message stating
[No memory card]
will be displayed.
72 - When the Indicators Provide No Help
G
Is the resolution of the image signal output from the computer higher
than UXGA (1,600 x 1,200)?
see page 21
G
Check to ensure that the mode supports the frequency of the image
signals output from the computer.
Refer to the computer 's instruction manual to discover how to amend the
resolution and frequency of the image signals output from the computer.
see page 21
G
Have the cables been connected correctly?
see page 20
G
Has the correct image input port been selected for the connection?
Press the [Source] buttons on the projector ([Comp], [S-Video], [Video] on
the remote control) to switch the image.
see page 33
G
Has the power supply to the connected computer or video equipment
been switched on?
see page 34
G
Note-type and liquid crystal type computers must output image signals
to the projector.
Image signals are not output externally simply because they are output to
the LCD screen under normal conditions, so the setting must be switched
to external output.
There are models for which image signals are not output to the LCD
screen when output externally.
see page 20
G
It is necessary to restart the system.
Unplug the power cord from the socket, plug it in again and then switch
on the power supply. If the same problem occurs again, unplug the power
cord from the socket and contact your dealer or "International Warranty
Conditions in "Safety Instructions/World-Wide Warranty Terms"
included in the package.
G
Has the memory card been inserted?
Insert the memory card in the card slot (on the projector.)